Wood Preservation Methods
The Biological research of wood and it’s renewable material is what is referred to as wood science. The processes and the tools used to utilize the material is what is known as wood technology. To be able to study wood it has to be compared to other products. Materials properties, ease of it being worked on and its value are among the few properties which are compared against those of wood and other materials. Wood has many advantages and this technology takes the advantages and utilizes them. The wide range of products where wood can be used is just one of the many advantages that give wood an upper hand over other products. It is also based on renewable resources. The other merit is that a part of the harvested material is at the same time used as energy to produce the product.
Protection of wooden structure and products is a must if you want to keep the good looks in place. This protection is from moisture and insects which are the biggest threat to wood. The water particles in the timber increase the rotting and the insects bore through the wood. Alkaline copper Quaternary or the ACQ has turned out to be a very effective way wood preservation. The protection of from this chemical is based on copper. Although being a good method to use for wood protection it has presents some few challenges. It has been seen corroding most metals for example aluminum in less than six months of its application. The species of the wood and the application of the wood will determine how many chemicals will be used on the wood. The level of chemical concentration will be determined by where the piece of wood is going to be put to use.
Another wood treating method that is fast being accepted is the use of copper metal. This method is being accepted fast because is friendly to wooden fasteners. Micronized copper wood preservative is the correct term to refer this type of preservation. The copper metal is applied to the wood as small microscopic particles injected into the wood at high pressure. The difference between this method and the other copper-based methods is that the copper is used as a metal rather than a dissolved material. When this process is used to treat timber the timber properties are increased highly. The time the wood products treated using this method last is longer other types of treatment.
Termites cannot eat through timber treated through this method. It is not corrosive to metals used in together with the product. When you use this method to treat wood, then you will not need to worry for at least ten years.